Advertisement
Physical Overview and Port Description
Figure 2-3
4
3
2
1
1
Power—Two-pin connector for Voltage In (VIN) and Ground (GND) to connect a 12 to 24 VDC
external power source.
2
CAN—A three-wire CAN bus is used to connect additional modules, including the Cisco Reader
Module, Cisco Input Module, and Cisco Output Module.
Note
3
SVR (Server)—When the LED is steady green, the Gateway is connected to a Cisco PAM
appliance.
4
Fast Ethernet interfaces—There are two 10/100 BASE-TX RJ-45 connectors:
5
Serial interface—The RS-485 interface is not supported in this release.
6
Wiegand interface—This interface can be configured as the following:
Note
Cisco Physical Access Gateway User Guide
2-4
Cisco Physical Access Gateway Ports and Connectors: Top View
2
5
6
11
Modules are connected using the CAN1 interface. The CAN2 interface is not supported
in this release.
•
ETH 0: connects the Gateway to the network. ETH 0 also supports Power over Ethernet
(PoE) for the device (optional).
ETH 1: connects the device to a PC to access the device configuration web page.
•
One 10-pin Wiegand/clock and data reader interface to connect a single door reader.
•
Two 5-pin Wiegand/clock and data interfaces to connect two door readers (for installations
•
where a 5-pin interface is sufficient).
Disconnect power from the Gateway or Reader module before connecting reader devices
to the modules. Connecting a reader device when the modules are powered can cause the
Gateway or Reader module to malfunction.
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
7
8
9 10
OL-32499-01
Advertisement
