Cisco CIAC-GW-K9 Installing And Configuring page 13

Chapter 2 Installing and Configuring the Cisco Physical Access Gateway
Figure 2-9
1
2
3
Figure 2-10
Gateway Module
On the last device in the CAN bus, set the CAN terminator switch to ON. The CAN terminator switch
Note
in included on the Reader, Input and Output modules only (the Gateway is always the first device in the
CAN bus).
OL-32499-01
CAN1 Connections: Cisco Physical Access Gateway and Reader Module
CAN+
Connects to the positive terminal of the CAN bus.
CAN-
Connects to the negative terminal of the CAN bus.
Shield
Connects to GND and/or Shield.
CAN Bus Wiring
CAN+
Sheild
CAN-
Reader Module
Installing the Cisco Physical Access Gateway
1
2
3
Input Module
Cisco Physical Access Gateway User Guide
Output Module
2-13