Advertisement
Configuring and Managing the Gateway Using a Direct Connection
Procedure
To change the password used to access the Gateway, perform the following procedure:
Click the User Management tab, as shown in
Step 1
Figure 2-14
Enter the Current Password.
Step 2
Step 3
Enter the New Password.
Step 4
Re-enter the new password to verify the setting.
Step 5
Click Update to save the changes.
The username cannot be changed.
Note
Tip
To reset the device to the default password, see the
page
Upgrading the Gateway Firmware Using a Direct Connection
You can also upgrade the firmware for a single Gateway, or all Gateways, over the network using the
Tip
Cisco PAM desktop software. For instructions, see the
Cisco Physical Access Gateway User Guide
2-20
User Management for the Cisco Physical Access Gateway
2-25.
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
Figure
2-14.
"Hard Reset (Restore Factory Defaults)" section on
Cisco Physical Access Manager User
Guide.
OL-32499-01
Advertisement
