Installation And Cautions - Calor De Hogar NTC-60 Manual

NT-200 controller
Set temp indicator
Heating indicator
Power button
Pause button
Time,temp set button
CHAPTER 2
Cautions:
 If the generator is installed at a place where difficult for customer access, the water supply
valve must be easy to access for emergencies.
 The maximum water pressure for electromagnetic valve is 2 bar. To protect the electromagnetic
valve from extremely high water pressure, please turn down the inlet slightly or install water
pressure relieving valve.
 Do not install saddle-backed or needle valves on the inlet. Please dredge and clean the pipe
before installation.
 No block valve should be installed in the steam pipelines. Strictly no blocked or blended pipe,
otherwise have negative affect on the flow of steam and condensate. The steam pipelines
should be installed with a slight angle so that the condensate can flow back to the generator or
the nozzle.
 Steam generator should be installed indoor to avoid frozen. The generator should be installed
and leveled with the arrow pointing upward at an easy-access place, otherwise do not switch
on.
 The steam pipeline must be copper pipes, all other material such as plastic, acrylic should not
be used since they cannot endure 302℉ or higher. temperature
 All inlet and apertures should be sealed to prevent any leakage of steam and to protect the
generator and customers.
 Draining water directly to the steam room from the water tank may cause serious scald and
damage the steam room.
1. Selecting the proper steam generator:
In order to achieve comfort and relaxation, as well as energy efficiency, the selection of the
Temp display
Set time indicator
NT-200
TEMP TEMP TEMP TIME TIME TIME
Nature
STEAM BATH CONTROL
ON ON
SET
OFF OFF
LIGHT
PAUSE
Light button

INSTALLATION AND CAUTIONS

Connector 2 P
Teat preserving
indicator
Heat Preserving
Adjust button
Figure 3
Connector 6 P
5