Table of Contents
Advertisement
a) For models with two groups of heating elements (1~6 elements): if the indicator is red or
green, then the actual temperature is below the setting value and both two groups of heating
elements are working; if the indicator is blue, then the actual temperature is 4℉ higher than
the setting value so only one group of heating elements is working.
b) For models with three groups of heating elements (9 elements): if the indicator is red, then
the actual temperature is below the setting value more than 4℉ and all three groups of
heating elements are working; if the indicator is green, then the actual temperature is less
than 4℉ lower than the setting value so two groups of heating elements are working; if the
indicator is blue, then the actual temperature is 4℉ higher than the setting value, so only
one group of elements is working.
Insulation: indicated by the LED on the right of the panel with label " ". If the current
7)
temperature is more than 4℉ above the setting temperature, all heating elements stop working
and the system is under insulation function.
2. FUNCTION BUTTONS AND OPERATION
ON/OFF:
to switch on and off of the whole system. Press this button can switch on the
generator and open the water inlet electromagnetic valve to fill in water. When the water level
reaches the required minimum water level, system begins to heat up (if current temperature is
lower than setting temperature). Once the water level reaches its maximum level, inlet valve
closes and the system enter the automatic working process. If the system was shut off by
pressing ON/OFF button previously, system will adapt the default temperature and time
setting; otherwise if the system is shut off automatically when setting time is up, system will
adapt the previous temperature and time setting. Then system begins to heat up and produce
steam after several minutes. Press the ON/OFF button again will shut down the system
manually and the system will drain automatically.
SET:
Temperature and Time setting button. Press once to adjust the temperature. The LCD and the
red LED on the left will blink and display the previous setting temperature. If the system has
been turned off and restarted, the LCD displays the default temperature 109
"▲" or "▼" button to adjust and press "SET" again to confirm your setting. At this
time, the LCD and LEDs on the right blink and display the previous setting time or the default
setting time 45 minutes if the system has been turned off and restarted, or the remaining
working time(during working mode), you could set the working time now. Press "▲" or
"▼" button to adjust the working time to the value you want, or press "▲" button until
the LCD displays "CH"and then press "SET" to confirm, after that the system
automatically enters long-term working mode. The available temperature range is 95℉～
131℉，and the default temperature is 109
LEDs on the right side of the LCD are on and the top one blinks. When the working time is
set, the maximum working time is 60 minutes and the default working time is 45 minutes.
PAUSE:
Press this button to save energy without shut down the system. All heating elements
switch off. The heating indicator turns off, the insulation indicator blinks, and all function
buttons are not function except "ON/OFF" button and "LIGHT" button. If is not in
long-term mode, system will automatically drain and switch off once the working time is over.
14
℉
,When the system is in long-term mode, five red
℉
, then press the
Advertisement
Table of Contents
