Makita JV102D Instruction Manual page 7

1. Lock/unlock button 2. Start/stop button
NOTE: If the tool is left for 10 seconds without any
operation in the standby mode, the tool automatically
turns off and the lamp goes off.
NOTE: You can also stop and turn off the tool by
pressing the lock/unlock button while the tool is
operating.
CAUTION:
turn off the lamp, press the lock/unlock button again.
NOTICE:
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
1.
the lowest speed at 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Workpiece
Wood
Mild steel
Stainless steel
Aluminum
Plastics
1
NOTICE:
2
Electronic function
easy operation.
and makes the tool start smoothly.
with the cutting line easily, the tool automatically
reduces the rotation speed until the tool starts cut-
is set at 2 or higher. Once the tool starts cutting
the workpiece, the tool speed reaches the preset
speed and keeps the speed until the tool stops.
NOTE: When the temperature is low, this function
may not be available.
function
steps below.
1. Make sure that the tool is turned off.
2.
Press the lock/unlock button to turn on the tool.
4.
1
again, perform the same procedure again.
NOTE: If the soft no-load rotation function is disabled,
the lamp blinks twice when the tool is turned on.
NOTE: You can also disable or enable the soft
no-load rotation function by changing the speed
7 ENGLISH
Number
4 - 5
3 - 5
3 - 4
3 - 5
1 - 4