Makita JV102D Instruction Manual page 6

When the battery is operated in a manner that causes
it to draw an abnormally high current, the tool automat-
ically stops without any indication. In this situation, turn
the tool off and stop the application that caused the tool
When the tool or battery is overheated, the tool stops
automatically and the lamp blinks. In this case, let the
tool and battery cool before turning the tool on again.
When the battery capacity is not enough, the tool stops
automatically. If you turn the tool on, the motor runs
again but stops soon. In this case, remove the battery
from the tool and charge the battery.
capacity
Only for battery cartridges with the indicator
1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
light up for a few seconds.
Indicator lamps
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
1
2
Remaining
capacity
Off
75% to 100%
50% to 75%
25% to 50%
0% to 25%
1. Cutting action changing lever
stroke and greatly increases cutting speed.
changing lever to the desired cutting action position.
Refer to the table to select the appropriate cutting
action.
Position
0
I
II
III
lock/unlock button in the standby mode.
6 ENGLISH
1
Cutting action Applications
Straight line cutting For cutting mild
action steel, stainless
steel and plastics.
For clean cuts in
wood and plywood.
Small orbit cutting For cutting mild
action steel, aluminum
and hard wood.
Medium orbit For cutting wood
cutting action and plywood.
For fast cutting in
aluminum and mild
steel.
Large orbit cutting For fast cutting in
action wood and plywood.