Plunge Cutting - Makita JV102D Instruction Manual

Cutouts
Cutouts can be made with either of two methods
"Boring a starting hole" or "Plunge cutting".
For internal cutouts without a lead-in cut from an edge,
pre-drill a starting hole 12 mm or more in diameter.

Plunge cutting

You need not bore a starting hole or make a lead-in cut
if you carefully do as follows.
1.
piece surface.
2. Apply pressure to the tool so that the front edge of
the base will not move when you switch on the tool and
gently lower the back end of the tool slowly.
lower the base of the tool down onto the workpiece
surface.
4. Complete the cut in the normal manner.
Metal cutting
greased instead of using a coolant.
Dust extraction
Clean cutting operations can be performed by connect-
ing this tool to a Makita vacuum cleaner.
-
1. Dust cover
10 ENGLISH
1