Makita JV102D Instruction Manual page 12

on the side of the base with the fence guide facing
down. Slide the rip fence to the desired cutting width
position, then tighten the bolt to secure it.
2
1. Hex wrench 2. Bolt
Circular cuts
When cutting circles or arcs of 170 mm or less in radius,
install the rip fence as follows.
1
1.
1. Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
2. Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded knob
onto the pin to secure the pin.
2
1. 2. Fence guide
4. Pin
3
4
Fence guide 4. Rip fence
1
3
4
Rip fence
Slide the rip fence to the desired cutting radius,
base all the way forward.
NOTE:
B-26 or B-27 when cutting circles or arcs.
Optional accessory
CAUTION:
1. Base 2. Anti-splintering device
For splinter-free cuts, the anti-splintering device can
tool base.
When you use the cover plate, install the anti-splintering
device onto the cover plate.
Optional accessory
1. Cover plate 2. Base
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
12 ENGLISH
1
2
1
2