Table of Contents
Advertisement
INTENDED USE
This toaster is designed to toast breads bagels or
English muffins.Do not attempt to toast croissants.
Their butter content will cause them to stick to the
conveyor. Do not attempt to toast products that have
been buttered or spread with jam or other coating.
Do not attempt to bake in the toaster.
INSTALLATION
1. After you have removed the toaster from the
carton, inspect the unit for signs of damage. If
there is damage to the unit:
Notify carrier within 24 hours after delivery.
Save carton and packing materials for inspection
purposes.
Contact your local dealer or, if purchased di-
rectly, the Prince Castle Customer Sales Depart-
ment at 1-630-462-8800 to arrange for a replace-
ment to be sent.
2. Verify that all parts have been received. Remove
Protective Coating.
3. Attach four (4) legs to toaster by screwing in
each leg clockwise.
4. Adjust legs so toaster is level.
5. Remove packaging from bun slide and install bun
slide in toaster by hooking it into the two pins in
the rear of the chamber. (See Detail 1)
6. Attach heat shield by hooking its top tabs onto
the two mounting pins just under the crumb tray
then allow the shield to swing down so it touches
the two lower mounting pins. Lift shield slightly
to hook onto the lower pins. Attach the product
slide tray by hooking its tabs onto the two
uppper mounting pins at the top front of the
toaster. (See Detail 2)
7. The toaster fan located on the bottom of the
toaster in the rear draws in cool room air and
circulates it through the toaster sides and tops.
To insure adequate heat dissipation do not posi-
tion the toaster where the fan would draw in hot
discharge from another appliance.
OPERATION
1. Plug unit into the proper voltage receptacle.
2. Set Power switch to "l" for On.
3. Turn upper and lower heater controls to maxi-
mum.
4. Allow 20 minutes for toaster to warm up.
5. Lay Bread, Bagel or Muffin, cut side up on the
inlet ramp and push into toaster until it slides on
to the conveyor chain. To control toast color,
vary the conveyor speed or the heater settings.
PREVENTIVE MAINTENANCE
The motors used on the Prince Castle Bun Toasters,
require monthly lubrication, 2-3 drops of 3 in 1 oil.
Motors that fail due to the lack of monthly lubrication
will not necessarily be covered under warranty. We
would like to have field service technicians stress
this maintenance requirement whenever failures
occur on these toasters.
Oil Hole
2
Advertisement
Table of Contents
