Table of Contents
Advertisement
Access
Register
Type
R/W
S220
Server or Client Mode
R/W
S221
Recovery Count
P P P P ersonal Network Control
R/W
S250
Number of Personal Network
(or Network)
R
S252
Modem Number
R
S253
Clients Count
R/W
S254
Client Addition
Name
Operation
Operation
Operation
Operation
ersonal Network Control
ersonal Network Control
ersonal Network Control
Indicates the operation of the Modem. When the Modem is
configured as Master (or Server), the S252 Register switches
automatically to 0xFF, while it switches to 0 when configured
as Slave (or Client).
'0' : Server (Network),
'1' : Client (Network),
'2' : Master,
'3': Slave (Default).
'3': Slave (Default).
'3': Slave (Default).
'3': Slave (Default).
Maximum recovery count in case of problems (Non-Ack
response to a message).
If this Register is at 0, the frames are not checked and
considered as still good (used for the tests).
Default: 2.
Default: 2.
Default: 2.
Default: 2.
This register gives the Personal Network (Network) number on
2 Bytes. Only the two members of a same Personal Network
can communicate with each other. Between 0 and 65535, it is
at 0 when the modem is not reset.
NOTE: To reset the register to 0 also resets the S252 Register
to 0.
Default: 0.
Default: 0.
Default: 0.
Default: 0.
Gives the Modem a unique number for a given Personal
Network. Number on one Byte is 0 when the Modem is not
reset, 1 if it is a Slave, between 1 and 6 if it is a Client and 255
if it is the Master.
Default: 0.
Default: 0.
Default: 0.
Default: 0.
Gives the Client count of a Master Modem or a Server.
Default: 0.
Default: 0.
Default: 0.
Default: 0.
Gives the number of a Client to be added in the already set
up network. This number should be between 1 and S253. Only
used on a Network Server.
Default: 0.
Default: 0.
Default: 0.
Default: 0.
Description
45
Advertisement
Table of Contents
