34
Appendix 2: Mechanical Drawings
Appendix 2: Mechanical Drawings
Appendix 2: Mechanical Drawings
Appendix 2: Mechanical Drawings
Drawing of the B900ss-20 Card
WARNING : In the "Rev. A" version of the card, the 1° connector contact of the J1 interface
WARNING :
WARNING :
WARNING :
(corresponding to the RTS Signal) is "below", as shown on the schematic.
(corresponding to the RTS Signal) is "below", as shown on the schematic.
(corresponding to the RTS Signal) is "below", as shown on the schematic.
(corresponding to the RTS Signal) is "below", as shown on the schematic.
In future ("Rev. B, Rev C, etc." versions, the 1° connector contact of the J1 interface
In future ("Rev. B, Rev C, etc." versions, the 1° connector contact of the J1 interface
In future ("Rev. B, Rev C, etc." versions, the 1° connector contact of the J1 interface
In future ("Rev. B, Rev C, etc." versions, the 1° connector contact of the J1 interface
(corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual
(corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual
(corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual
(corresponding to the RTS Signal) will be "above", meaning on the opposite side of its actual
position.
position.
position.
position.
Interface Connector
)
(14FMS-1.0SP-TF
1° Connector Contact
(RTS)
1.71"
In the "Rev. A" version of the card, the 1° connector contact of the J1 interface
In the "Rev. A" version of the card, the 1° connector contact of the J1 interface
In the "Rev. A" version of the card, the 1° connector contact of the J1 interface
Antenna Hot Point
Ground Antenna
(Cold Point)
1.57"