Table of Contents
Advertisement
24
4.2.3.
Registers Description
All
the
Modem
configuration, operating mode...) are sent on the serial link uncoded, ready
to be displayed using a software such as "Terminal" for Windows.
The response is a list of all the used registers with their value, each register
being separated from the other with the "Carriage Return" character (CR):
"S200=xx<CR>S201=yy<CR>...."
'AT/V':
'AT/V':
Uncoded Display of the Modem Software Version.
Uncoded Display of the Modem Software Version.
'AT/V':
'AT/V':
Uncoded Display of the Modem Software Version.
Uncoded Display of the Modem Software Version.
The information on the version number, conception date and the program
CRC are sent to the uncoded serial link, ready to be displayed using a
software such as "Terminal" for Windows.
The response is as follows: "Version: x.xx<CR> Date: MM/JJ/AAA<CR>
CheckSum: 0xhhhh<CR>"
'ATM1':
'ATM1':
'ATM1':
'ATM1':
Running in Acquisition Mode.
Running in Acquisition Mode.
Running in Acquisition Mode.
Running in Acquisition Mode.
This command allows to toggle from Normal Mode to Acquisition Mode.
The Modem is in Normal Mode by default.
If the command is given correctly, the modem responds with the OK
character 'O' (0x4F), otherwise with the error character 'E' (0x45).
'ATPx':
'ATPx':
Running in Standby or Normal mode.
Running in Standby
'ATPx':
'ATPx':
Running in Standby
Running in Standby
This command allows the user to toggle from Normal Mode to Standby
Mode and vice versa, according to the 'x' value. The Modem is in Normal
Mode by default.
Then there is: x = '0' ! Normal,
x = '1' ! Standby.
If the command is correctly given, the modem responds with the OK
character 'O' (0x4F), otherwise with the Error character 'E' (0x45).
'ATR':
'ATR':
'ATR':
'ATR':
Parameters Reset.
Parameters Reset.
Parameters Reset.
Parameters Reset.
This command allows the user to reprogram ALL the stored EEPROM
registers and give them their value by default.
If the command is correctly given, the modem responds with the OK
character, 'O' (0x4F), otherwise with the Error character 'E' (0x45).
This section is available in Appendix 6.
significant
registers
or Normal mode.
or Normal mode.
or Normal mode.
(radio
configuration,
serial
Advertisement
Table of Contents
