Acquisition Of Two Point-To-Point Modems - Adcon B900ss-20 Technical Manual

4.3. Utilization Example
4.3.1.

Acquisition of two Point-to-Point Modems

To send the following commands to the Modem, it is necessary to use software such as HyperTerminal for
Windows.
•
Parameterization of the "Master" Modem" :
User:
Modem response: O<CR>
User:
Modem response: O<CR>
User:
Modem response: O<CR>
User:
Modem response: O<CR>
User:
Modem response: O<CR>
User:
Modem response: O<CR>
User:
Modem response: O<CR>
User:
Modem response: O<CR>
User:
Modem response: O<CR>
The user now must configure the Slave Modem (see next page). Once this configuration has been
done and the "ATM1" command activated, they acquire themselves and the Master Modem
returns: S252=1<CR>
+++
ATS200=3<CR>
ATS201=0<CR>
ATS202=10<CR>
ATS203=20<CR>
ATS204=30<CR>
ATS220=2<CR>
ATS250=1<CR>
ATM1<CR>
/* run in Hayes Mode. */
/* Choice of Frequency table 3. */
/* Choice of No. 1 Synchronization
Frequency. */
/* Choice of No. 2 Synchronization Frequency. */
/* Choice of No. 3 Synchronization Frequency. */
/* Choice of No. 4 Synchronization Frequency. */
/* Choice of Master Mode. */
/* Choice of Personal Network No. */
/* Run in Acquisition Mode */
/* Indicates Acquisition done */
25