Auerswald TFS-Dialog 200 Operation & Installation Manual page 9

Start the programming
Press any bell button (you will
hear a tone) and hold it for
approx. 5 seconds until a
second signal tone can be
heard.
Execute the programming
First programming or after a programming break of more than 3 minutes
Input PIN
Short
Dial
and close
tone.
star.
with star
Additional programming
Dial
Wait for the end of the
star.
acknowledgement tone
Hint
You can make more than one
programming one after the other
without putting the handset
back. Exceptions are described.
Correct input will lead the
acknowledgement tone (six
tones). Wrong input will give an
occupied signal for 1-2 seconds.
Start again with star (*).
Within 3 minutes:
Pick up the handset of
one of the internal
telephones
Wait for the end of the
tones (five short
tones)
Dial the programming code of
the desired function.
For protection please set a PIN.
At subsequent programming the PIN
must not be entered again.
The programming mode ends 3
minutes after the last programming or
when a bell button is pressed.
Page 9 of 16
Programming
Dial the internal number
of the TFS-Dialog 200 –
the connection is
established.
Dial the
Wait for the end
programming
code of the
acknowledgement
desired function.
Wait for the end of the
acknowledgement tone
of the
tone