To Clean The Indoor Unit And User Interface - Daikin FTXP20L2V1B Operation Manual

CAUTION
Do NOT touch the heat exchanger fins. These fins are
sharp and could result in cutting injuries.
WARNING
Be carefull with ladders when working in high places.
6.2 To clean the indoor unit and user
interface
NOTICE
▪ Do NOT use gasoline, benzene, thinner polishing
powder or liquid insecticide. Possible consequence:
Discoloration and deformation.
▪ Do NOT use water or air of 40°C or higher. Possible
consequence: Discoloration and deformation.
▪ Do NOT use polishing compounds.
▪ Do NOT use
consequence: The surface finishing peels off.
DANGER: RISK OF ELECTROCUTION
Before cleaning, be sure to stop the operation, turn the
breaker off or pull out the supply cord. Otherwise, an
electric shock and injury may result.
1 Clean with a soft cloth. If it is difficult to remove stains, use
water or a neutral detergent.
6.3 To clean the front panel
1 Clean with a soft cloth. If it is difficult to remove stains, use
water or a neutral detergent.
6.4 To clean the air filters
1 Open the front panel.
2 Push the tab at the centre of each air filter, then pull it down.
3 Pull out the air filters.
1
FTXP20~35L2V1B
R32 split series
3P511999-1 – 2017.11
a scrubbing brush. Possible
2
6 Maintenance and service
4 Remove the titanium apatite deodorizing filter from the tabs.
5 Clean or replace each filter.
6 Wash the air filters with water or clean them with a vacuum
cleaner.
7 Soak in lukewarm water for about 10 to 15 minutes.
8 Set the air filters and the titanium apatite deodorizing filter back
to their original position.
9 Close the front panel by pushing the claws of the filter into the
slots at 3 locations (left, right, middle).
INFORMATION
▪ If the dust does NOT come off easily, wash the air
filters with a neutral detergent diluted in lukewarm
water. Dry the air filters in the shade.
▪ Be sure to remove the titanium apatite deodorizing
filter.
▪ It is recommended to clean the air filters every 2
weeks.
6.5 To clean the titanium apatite
deodorizing filter
INFORMATION
▪ Replace the filter every 3 years.
▪ Clean the filter with water every 6 months.
1 Remove the dust from the filter with a vacuum cleaner and soak
the filter for 10 to 15 minutes in warm water.
Operation manual
9