To Replace The Titanium Apatite Deodorizing Filter - Daikin FTXP20L2V1B Operation Manual

7 Troubleshooting
2 After washing, shake off remaining water and dry the filter in the
shade. Do NOT wring out the filter when removing water.
6.6 To replace the titanium apatite
deodorizing filter
1 Remove the filter from the tabs and prepare a new filter.
INFORMATION
Dispose of the old filter as non-flammable waste.
6.7 To take following items into
account before a long idle period
1 Set the mode to fan only by pressing
inside of the unit.
2 After operation stops, turn the breaker off.
3 Clean the air filters and replace them in their original position.
4 Remove the batteries from the user interface.
INFORMATION
It is recommended to have periodical maintenance
performed by a specialist. For specialist maintenance,
contact your dealer. Maintenance costs shall be borne by
the customer.
In certain operating conditions the inside of the unit may
get dirty after several seasons of use. This results in poor
performance.
7 Troubleshooting
If one of the following malfunctions occur, take the measures shown
below and contact your dealer.
WARNING
Stop operation and shut off the power if anything
unusual occurs (burning smells etc.).
Leaving the unit running under such circumstances may
cause breakage, electric shock or fire. Contact your dealer.
The system MUST be repaired by a qualified service person:
Malfunction
If a safety device such as a fuse, a
breaker or an earth leakage breaker
frequently actuates or the ON/OFF
switch does NOT properly work.
Operation manual
10
button to dry the
Measure
Turn OFF the main power
switch.
Malfunction
If water leaks from the unit.
The operation switch does NOT work
well.
If the user interface display indicates the
unit number, the operation lamp flashes
and the malfunction code appears.
If the system does NOT properly operate except for the above
mentioned cases and none of the above mentioned malfunctions is
evident, investigate the system according to the following
procedures.
Malfunction
If the system does ▪ Check if there is no power failure. Wait
NOT operate at all. until power is restored. If a power failure
occurs during operation, the system
automatically restarts immediately after
power is restored.
▪ Check if no fuse has blown or breaker is
activated. Change the fuse or reset the
breaker if necessary.
▪ Check the batteries of the user interface.
The system suddenly ▪ Check if the air inlet or outlet of the
stops operating. outdoor or indoor unit is NOT blocked by
obstacles. Remove any obstacles and
make sure the air can flow freely.
▪ The air conditioner may stop operating
after sudden large voltage fluctuations to
protect the system. It automatically
resumes operation after about 3 minutes.
The system operates, ▪ Check the airflow rate setting. Refer to
but cooling or heating "4.3.2 Airflow rate" on
is insufficient.
▪ Check the temperature setting. Refer to
"4.3.1 To start/stop operation and to set
the temperature" on
▪ Check if the airflow direction setting is
appropriate. Refer to
direction" on
▪ Check if the air inlet or outlet of outdoor
or indoor unit is NOT blocked by
obstacles. Remove any obstacles and
make sure the air can flow freely.
The system operates ▪ The air conditioner may be warming up
but cooling or heating for heat operation. Wait for about 1 to 4
is insufficient (air is minutes.
NOT blown from the
▪ The unit may be in defrost operation.
unit).
The system operates, ▪ Check if the air filters are clogged. Clean
but cooling or heating the air filters. See
is insufficient (air is service" on
blown from the unit).
▪ Check for open doors or windows. Close
doors and windows to prevent wind from
coming in.
▪ Check if the unit operates in Econo
operation.
operation" on
▪ Check if there is any furniture directly
under or next to the indoor unit. Move the
furniture.
An abnormal function The air conditioner may malfunction
happens during because of lightning or radio waves. Turn
operation. the breaker OFF and back ON.
Measure
Stop the operation.
Turn OFF the power
supply.
Notify your installer and
report the malfunction
code.
Measure
page 5.
page 5..
"4.3.3 Airflow
page 6.
"6 Maintenance and
page 8.
Refer to "4.3.6 Econo
page 7.
FTXP20~35L2V1B
R32 split series
3P511999-1 – 2017.11