Adding and Replacing Parts
Before You Begin
This chapter provides procedures for removing and installing the components
in your Tablet-PC. Unless otherwise noted, each procedure assumes that the
following conditions exist:
•
You have performed the steps in "Turning Off Your Tablet-PC" on page 139
and "Before Working Inside Your Tablet-PC" on page 140.
•
You have read the safety information in the Dell™ Product Information
Guide.
Recommended Tools
The procedures in this document may require the following tools:
•
Small flat-blade screwdriver
•
#0 Phillips screwdriver
•
#1 Phillips screwdriver
•
Small plastic scribe
•
Flash BIOS update program CD
Turning Off Your Tablet-PC
NOTICE:
To avoid losing data, save and close all open files and exit all open
programs before you turn off your Tablet-PC.
NOTE:
By default, the power button is configured to initiate the sleep state rather
than the shut down state. Follow the procedure below to shut down your Tablet-PC.
1 Shut down the operating system:
Save and close all open files and exit all open programs.
a
Adding and Replacing Parts
139