Voice Recognition - Fiat Connect 7.0 Manual

Troubleshooting For Voice
Recognition
If you do not understand an operation
method while in the voice recognition
mode, say "Tutorial" or "Help".
Commands Usable Anytime
During Voice Recognition
"Go Back" and "Cancel" are commands
which can be used at anytime during

voice recognition.

Returning to previous operation
To return to the previous operation, say,
"Go Back" while in voice recognition
mode.
Cancel
To put the Bluetooth Hands-Free
system in standby mode, say, "Cancel"
while in voice recognition mode.
Deterioration In Rate And Quality
of Voice Recognition
To Prevent A Deterioration In The Voice
Recognition Rate And Voice Quality,
The Following Points Should Be
Observed:
34
The voice recognition cannot be
performed while voice guidance or the
beep sound is operating. Wait until
the voice guidance or the beep sound
is finished before saying your
commands.
Phone related commands are
available only when your phone is
connected via Bluetooth. Make sure
your phone is connected via Bluetooth
before you operate phone related
voice commands.
Music play commands, such as Play
Artist and Play Album can be used
only in USB audio mode.
Do not speak too slowly or loudly (do
not yell).
Speak clearly, without pausing
between words or numbers.
Dialects or different wording other
than hands-free prompts cannot be
recognized by voice recognition. Speak
in the wording specified by the voice
commands.
It is not necessary to face the
microphone or approach it. Speak the
voice commands while maintaining a
safe driving position.
Close the windows and/or the
convertible top to reduce loud noises from
outside the vehicle, or turn down the
airflow of the air-conditioning system while
Bluetooth Hands-Free is being used.
Make sure the vents are not directing
air up towards the microphone.
Note: If the voice recognition perfor-
mance is not satisfactory. Refer to "
Voice Recognition Related Problems"
paragraph.
Audio Operation Using
Voice Recognition
Main Audio Operation
The below commands are examples of
the available commands.
When the talk button is pressed and the
following command is spoken aloud,
the audio can be operated.
The commands in the ( ) can be
omitted. The specified name and
number are put into the { }.