Seat Position; Manual Recline Seatback Adjustment - Pride Mobility JET 3 Owner's Manual

V . C O M F O R T A D J U S T M E N T S
NOTE: Change the seat dump by raising or lowering only
one set of towers (front or back).
10. Reinstall the retaining clips from step 8.
11. Remove each screw from the trapeze bars and apply
thread lock.
12. Reinstall each screw into the trapeze bars and tighten.
13. Reinstall the seat.
14. Reconnect the controller connectors to the power
module.
15. Reinstall the rear shroud and tighten the fasteners.

Seat Position

You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Unplug the controller connectors from the power
module. See figure 7.
3. Remove the seat from the power base. See figure 10.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same number
of holes either forward or backward. See figure 15.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller connectors into the power pod.

Manual Recline Seatback Adjustment

If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat base.
See figure 16.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Jet 3 Ultra
Figure 15. Seat Mounting Holes
Figure 16. Manual Recline Seatback Adjustment
www.pridemobility.com
SEAT MOUNTING HOLES
SEATBACK RELEASE LEVER
25