Pride Hurricane PMV Owner's Manual page 27

V I . B A T T E R I E S A N D C H A R G I N G
How can I get maximum range or distance per charge?
Rarely will you have ideal driving conditions—smooth, flat, hard driving surfaces with no wind or curves. Often, you will
face hills, pavement cracks, uneven and loosely packed surfaces, curves, and wind, all of which affect the distance or
running time per battery charge. Below are a few suggestions for obtaining the maximum range per battery charge.
Always fully charge your PMV's batteries prior to daily use.
Maintain 30-35 psi in each tire.
Plan your route ahead to avoid as many hills, cracked, broken, or soft surfaces as possible.
Limit your baggage weight to essential items.
Try to maintain an even speed while your PMV is in motion.
Avoid stop-and-go driving.
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both AGM and Gel Cell are deep-cycle
batteries that are similar in performance. Do not use wet-cell batteries, which have removable caps.
WARNING! Corrosive chemicals are contained in batteries. Use only AGM or Gel-Cell
batteries to reduce the risk of leakage or explosive conditions.
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
How do I change a battery?
WARNING! Contact your Pride Provider if you have any questions regarding the batteries in your
PMV.
WARNING! Battery posts, terminals and related accessories contain lead and
lead compounds. Wear goggles and gloves when handling batteries and wash
hands after handling.
WARNING! Always use two batteries of the exact same type, chemistry and
amp-hour (Ah) capacity. Refer to the specifications table in this manual and in
the manual supplied with the battery charger for recommended type and
capacities.
WARNING! Do not replace the batteries while the PMV is occupied.
WARNING! The batteries on your PMV should only be servcied or replaced by an authorised
Pride Provider or a qualified technician.
1. Remove the seat and rear shroud.
2. Disconnect the battery tie-down strap.
3. Disconnect the T-handle battery harness.
4. Disconnect the battery cables from the battery terminals.
5. Remove the old batteries.
6. Place new batteries into the battery wells.
7. Connect the red battery cable to the positive (+) battery terminal.
8. Connect the black battery cable to the negative (-) battery terminal.
9. Reconnect the T-handle battery harness.
10. Reconnect the battery tie-down strap.
11. Reinstall the rear shroud and seat.
Hurricane www.pridemobility.com
27