Page 1
Blood Pressure Monitor TMB-1018-A Arm Type IFU/TRANSTEK/TMB-1018-A/EN/2016_01 Thank you very much for selecting TRANSTEK Blood Pressure Monitor TMB-1018-A. Guangdong Transtek Medical Electronics Co., Ltd. Zone A, No.105 ,Dongli Road, Torch Development District, To use the monitor correctly and safely, please read the manual Zhongshan,528437,Guangdong,China thoroughly.
Page 2
CATALOGUE CATALOGUE Table of Contents INTRODUCTION……………………………………………………………………………………2 General Description Safety Information LCD Display Signal Monitor Components BEFORE YOU START…………………………………………………………………………..6 The Choice of Power Supply Installing and Replacing the Batteries Setting Date, Time and Measurement Unit MEASUREMENT…………………………………………………………………………………...9 Tie the Cuff Start the Measurement DATA MANAGEMENT…………………………………………………………………………..11 Recall the Records Delete the Records...
If you have any problems with this device, such as setting up, maintaining or using, please contact the SERVICE PERSONNEL of Transtek. Don’t open or repair the device by yourself. Please report to Transtek if any unexpected operation or events occur.
Shocking reminding Shocking will result in inaccurate 1.Blood Pressure Monitor 2.Cuff Type BF applied part Average The average of blood pressure (TMB-1018-A) Recalling The records will be showed Arrhythmia Irregular heartbeat Grade The grade of the blood pressure. 3. 4*AAA batteries 4.User manual...
BEFORE YOU START BEFORE YOU START The Choice of Power Supply Setting Date, Time and Measurement Unit 1.Battery powered mode: It is important to set the clock before using your blood pressure 6VDC 4*AAA batteries monitor, so that a time stamp can be assigned to each record that 2.AC adaptor powered mode: is stored in the memory.
BEFORE YOU START MEASUREMENT Tie the Cuff 4.Repeat steps 2 and 3 to set the [MONTH] and [DAY]. 1.Tie the cuff on your upper arm, then position the tube off-center toward the inner side of arm in line with the little finger. START STOP START STOP START STOP...
MEASUREMENT DATA MANAGEMENT Start the Measurement Recall the Records 1.When the monitor is off,press the 1. When the monitor is off, press the “START/STOP” to turn on the “MEM” to show the START STOP average of the last three monitor, and it will finish the whole measurement.
DATA MANAGEMENT INFORMATION FOR USER Delete the Records Tips for Measurement If you did not get the correct measurement, you can delete all Measurements may be inaccurate if taken in the following results by following steps below. circumstances. 1.When the monitor is off, hold pressing “MEM”...
INFORMATION FOR USER ABOUT BLOOD PRESSURE What are systolic pressure and diastolic pressure? Maintenance When ventricles contract and pump blood out In order to get the best performance, please follow the Systolic Diastolic of the heart, the blood pressure reaches its instructions below.
Page 10
ABOUT BLOOD PRESSURE TROUBLESHOOTING This section includes a list of error messages and frequently Why does my blood asked questions for problems you may encounter with your blood pressure fluctuate pressure monitor. If the products not operating as you think it throughout the day? should, check here before arranging for servicing.
Atmospheric pressure: 86kPa to 106kPa For more information about our products, please visit www.transtek.cn.you Temperature:-20℃-60℃ Storage & transportation can get customer service, usual problems and customer download, transtek will Relative Humidity: 10%RH-93%RH condition serve you anytime. Atmospheric Pressure: 50kPa-106 kPa Manufactured by: Guangdong Transtek Medical Electronics Co., Ltd.
COMPLIED EUROPEAN EMC GUIDANCE STANDARDS LIST Complied European Standards List EMC Guidance 1) * This product needs special precautions regarding EMC and needs to be Risk management EN ISO 14971:2012 Medical devices - Application of risk installed and put into service according to the EMC information provided, and management to medical devices this unit can be affected by portable and mobile RF communications equipment.
EMC GUIDANCE EMC GUIDANCE Table 2 Guidance and MANUFACTURER’s declaration – electromagnetic Table 4 Guidance and MANUFACTURER’s declaration – electromagnetic IMMUNITY – for ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING IMMUNITY – for all ME EQUIPMENT and ME SYSTEMS Guidance and manufacturer’s declaration –...
Page 14
EMC GUIDANCE Table 6 Recommended separation distances between portable and mobile RF communications equipment and the ME EQUIPMENT or ME SYSTEM – for ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING Recommended separation distances between portable and mobile RF communications equipment and the device. The device is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
Need help?
Do you have a question about the TMB-1018-A and is the answer not in the manual?
Questions and answers