Connecting To Web-Based Interface - D-Link DIR-615A User Manual

DIR-615A Wireless N300 Router
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (create a WAN connection, change the parameters of the wireless network,
specify the settings of the firewall, etc.).
Router DIR-615A with default settings cannot connect to the Internet. To get started, please
!
set your own password for access to the web-based interface and change the WLAN name
(SSID); then, if needed, configure other settings recommended by your ISP.
Start a web browser (see the Before You Begin section, page 16). In the address bar of the web
browser, enter the IP address of the router (by default, the following IP address is specified:
192.168.0.1). Press the Enter key.
Figure 15. Connecting to the web-based interface of the DIR-615A device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 35).
Figure 16. The page for running the Initial Configuration Wizard.
Page 29 of 174
Installation and Connection