D-Link DIR-615A User Manual page 123

DIR-615A Wireless N300 Router
User Manual
You can specify the following parameters:
Parameter
Name
Enable
Type
VLAN ID
Untagged ports
Tagged ports
Click the APPLY button.
To edit an existing group, select the relevant group in the table. On the page displayed, change the
parameters and click the APPLY button.
To remove an existing group, select the checkbox located to the left of the relevant line in the table
and click the Delete button.
A name for the port for easier identification.
Move the switch to the right to allow using this group of ports.
The type of the VLAN.
Untagged NAT. The group of this type is an external connection
with address translation. It is mostly used to transmit untagged
traffic. When this value is selected, the VLAN ID field and the
Tagged ports section are not displayed. Only one group of this
type can exist in the system.
Tagged NAT. The group of this type is an external connection with
address translation. It is mostly used to connect to the Internet. Later
the VLAN which identifier is specified in the VLAN ID field is used
to create a WAN connection (on the Connections Setup / WAN
When this value is selected, the Untagged ports section is
page).
not displayed.
Bridge. The group of this type is a transparent connection between
an internal port and an external connection. It is mostly used to
connect IPTV set-top boxes.
An identifier of the VLAN to which this group of ports will be
assigned.
The section includes the ports that can be added to the group.
To add a port to the group, select the checkbox located to the left of
the relevant port.
To remove a port from the group, deselect the checkbox located to
the left of the relevant port.
Select an available value to assign it to this group. To do this, select
the checkbox located to the left of the relevant port.
Page 123 of 174
Configuring via Web-based Interface
Description