Download Print this page
   

Advertisement

Cark 112 Installation Guide
11.10.2001
10:25
Sivu 1
CARK112

Advertisement

   Also See for Nokia CARK112

   Summary of Contents for Nokia CARK112

  • Page 1: Installation Guide

    Cark 112 Installation Guide 11.10.2001 10:25 Sivu 1 CARK112 Installation Guide...

  • Page 2

    The terms of warranty demand that this car kit be installed by an experienced installer and only genuine Nokia parts are used. An end user should never attempt to install this car kit without professional assistance as the installation requires special tools and knowledge.

  • Page 3

    WARNINGS 1. ENSURE THAT THE VEHICLE’S BATTERY IS DISCON- NECTED BEFORE YOU START THE INSTALLATION PROCEDURE, AND THAT IT REMAINS DISCONNECTED DURING THE PROCEDURE. 2. DO NOT SMOKE OR USE OPEN FLAMES WHEN WORK- ING NEAR THE VEHICLE’S FUEL SYSTEM. 3.

  • Page 4

    Unpacking Carefully unpack the equipment and ensure that the following items are present. Wireless Hands Free Unit HFW-1 Remote Control Button CUW-2 Power Cable PCU-4 Mounting Plate MKU-1 HF Microphone HFM-8 HF Speaker HFS-12 MKU–1 HFW–1 PCU–4 HFS–12 HFM–8 CUW–2...

  • Page 5

    Installation After tightening the MKU-1 screws, secure HFW-1 installation to the MKU-1 mounting plate with the screw going through HFW-1. The Nokia logo lid is placed on the HFW-1 to cover the recess.

  • Page 6

    (rotary switch) in the CUW-2. It is possible to receive a call or to dial by pressing a send/end push button in the CUW-2 (also voice dialing). To read more about the use of CUW-2, see CARK112 User’s Guide. Installation The positioning of the Remote Control Button CUW-2 is impor- tant, to achieve the most comfortable position for the user.

  • Page 7

    To attach the Remote Control Button: 1. Detach the two grip pads from each other. 2. Peel off the protective sheet (pad with soft fabric) from the adhesive side and attach the pad to the desired location in the car. Make sure the surface where you attach this pad is dry and clean from dirt and dust.

  • Page 8

    Power Cable PCU-4 The power cable connects the wireless handsfree unit HFW-1 to the vehicle’s power supply (DC socket). The red wire must be connected to the + voltage on the vehi- cle’s power supply via the supplied fused connector. The black wire must be attached to a good negative GND connection.

  • Page 9

    During the call, switch off the engine. Ensure that the phone is operational with the engine running and with the engine switched off. For operating information refer to the CARK112 User’s Guide or User’s Guide supplied with the phone.

  • Page 10

    Cark 112 Installation Guide 11.10.2001 10:25 Sivu 2...

Comments to this Manuals

Symbols: 0
Latest comments: