Table of Contents
Advertisement
Figure 23. Closing the Handle
6. Verify that the disk drive module that you have just installed is aligned with
7. The green Activity 1 light and the amber Check 2 light both come on and
20
ProFibre Storage Array: Operator's Guide
Attention: The speed of the fans may decrease.
the sides of the unit and that no gap exists between this module and the
modules that are next to it.
Verify also that the front edge of this disk drive module aligns with the front
edges of the modules next to it.
If the disk drive module is not correctly aligned, remove it (see 1 on page 18)
and reinstall it (steps 4 through 6 above).
then go out. If the Check light stays on, verify that the new disk drive module
has been correctly installed. If it has been correctly installed, refer to the
SANArray Manager Client Software for Mylex External Disk Array Controllers:
Installation and User Manual, GA18-7717 for guidance on how to obtain
information about the problem.
Advertisement
Table of Contents
