Table of Contents
Advertisement
Figure 21. Removing a Disk Drive Module
Attention: The fan speed may increase. Do not leave the slot empty for more
than 30 minutes; if you do, the unit, and the disk drive modules, may overheat
and be damaged.
4. With one hand giving support to the base of the replacement module and the
other hand holding the handle 1 , insert the module and push it into the slot.
When the handle touches the front surface of the unit, the module stops. Note
that the disk drive module is not yet fully inserted.
Figure 22. Inserting a Disk Drive Module
5. While continuing to push the disk drive module into the slot, slowly close the
handle 1 until it stops with a click. This action fully inserts the module into
the connector at the back of the slot.
Chapter 3. Exchanging Disk Drive Modules and Fan-and-Power-Supply Assemblies
19
Advertisement
Table of Contents
