The Configuration - Alcatel-Lucent 7210 Sas-x Service Manual

The vc-switching parameter must be specified at the time the VLL service is created. Note that
when the vc-switching parameter is specified, you are configuring an S-PE. This is a pseudowire
switching point (switching from one pseudowire to another). Therefore, you cannot add a SAP to

the configuration.

The following example show the configuration when a SAP is added to a pseudowire. The CLI
generates an error response if you attempt to create a SAP. VC switching is only needed on the
pseudowire at the S-PE.
*A:ALA-701>config>service# epipe 28 customer 1 create vc-switching
*A:ALA-701>config>service>epipe$ sap 1/1/3 create
MINOR: SVCMGR #1311 SAP is not allowed under PW switching service
*A:ALA-701>config>service>epipe$
Use the following CLI syntax to create pseudowire switching VLL services.
CLI Syntax: config>service# epipe service-id [customer customer-id][vpn vpn-id][vc-switch-
ing]
The following displays an example of the command usage to configure VLL pseudowire
switching services:
*A:7210SAS>config>service# info
.............
epipe 1 customer 1 vpn 1 vc-switching create
7210 SAS-X, R6 OS Services Guide
description description-string
spoke-sdp sdp-id:vc-id
description "Default epipe description for service id 1"
spoke-sdp 1:1 vc-type vlan create
description "Description for Sdp Bind 1 for Svc ID 1"
ingress
vc-label 4501
exit
egress
vc-label 4501
exit
control-word
pw-path-id
agi 1:1
saii-type2 1:0.0.0.2:1
taii-type2 1:0.0.0.1:1
exit
control-channel-status
refresh-timer 10
no shutdown
exit
no shutdown
exit
spoke-sdp 1001:1 vc-type vlan create
description "Description for Sdp Bind 1001 for Svc ID 1"
ingress
vc-label 5501
exit
egress
vc-label 5501
exit
control-word
Virtual Leased Line Services
Page 179