AEG BPK742320M User Manual page 41

Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
14.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
activated.
The Child Lock is on.
The door is not closed cor-
rectly.
The fuse is blown.
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is an electrical fault.
You left the dish in the oven
for too long.
The demo mode is activa-
ted.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
ENGLISH
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Basic Settings" in
"Daily use" chapter.
41