Table of Contents
Advertisement
Accessories
1.2 Installations
1.2.1 Antenna
■ Attaching the Antenna
1. Hold the antenna by its base.
2. Align the grooves at the base of the
antenna with the protrusions on the
antenna connector.
3. Slide the antenna down and turn it
clockwise until it stops.
4. Confirm that the antenna is securely
connected. Check the connection
from time to time.
■ Removing the Antenna
Turn the antenna counter-clockwise to disconnect the antenna.
NOTE:
NOTE
Do not use third-party antenna as it may radiate more RF that
exceeds SAR limit guidances.
1.2.2 Belt Clip
■ Attaching the Belt Clip
1. Put the belt clip on the back of the
unit, and turn the screw clockwise
until it stops.
2. Confirm that the belt clip is securely
attached.
* Tighten up the screw occasionally.
■ Removing the Belt Clip
Turn the screw counter-clockwise to
remove the belt clip.
Caution: Use the screws of specified size only. Others may cause
damage to the product. (screws size M 3mm x 4mm)
12
Advertisement
Table of Contents
