Adjusting The Seat's Side To Side Movement On The C846 Recumbent - Precor Bicycle-mounted Child Seat C846 Owner's Manual

Commercial self-powered cycle

Hide thumbs Also See for Bicycle-mounted Child Seat C846:

Table of Contents

ADJUSTING THE SEAT'S SIDE TO SIDE MOVEMENT ON THE

C846 RECUMBENT.

Periodically check the seat on the C846 Recumbent. Take the following steps to

eliminate any side to side rocking movement:

1. To determine if the seat rocks side to side, straddle the base with your feet

firmly planted on the floor.

2. Sit on the seat and face the display console. Gently, move your upper body

side to side. If the seat rocks side to side with you, you need to "realign" the

center wheels that run underneath the seat. Adjustment bolts are located on

the both sides of the seat rail.

To realign the seat's center wheels, take the following steps:

1. Obtain a 3/16-inch and 5/16-inch hex key.

Diagram 17 Adjusting the

wheel locks.

Adjustment plate

Loosen

adjustment bolts

Wheel lock

adjustment key

2. Start on one side of the cycle and loosen the two adjustment bolts with the 3/

16-inch hex key as shown in Diagram 17.

3. Using a 5/16-inch hex key, turn the wheel lock adjustment key clockwise

1/4 turn. This thrusts the center wheel up inside the top rail. Continue

holding the hex key in place while you tighten the adjustment bolts with

the 3/16-inch hex key.

4. Remove the hex keys and perform step 3 on the opposite side of the seat.

5. Check that the seat no longer rocks from side to side. If rocking movement

continues, you may need to repeat the process.

page 44

Table of Contents