XYZ Printing da Vinci 1.1 Plus Quick Manual page 8

Unload fi lament
Please always complete the procedure for " Unload Filament " before changing a new cartridge.
1 Select "Filament" > "Cartridge" > "Unload" on the screen
2 F i l a m e n t i s u n l oa d e d f ro m
extruder automatically. Gently
pull filament out from the guide
hole when prompted.
Filament troubleshooting
When the filament is loaded automatically or is stuck in the extruder module, please first unload filament by
following the steps above. And then press on the black rubber fixers on either ends of the filament tube. You may
also follow the instructions on the screen for troubleshooting.
Status
1
If the filament is stuck in the
extruder module, press the release
arm on the side of the extruder
module to extract the stuck
filament.
P 8
3 When filament is pulled out,
press .
2
If the filament is stuck at the
entrance of the guide tube,
please press the release arm by
the entrance to extract the stuck
filament.
4 Remove cartridge locker
and the catridge.
3
After removing the filament, plug
the filament tube directly back to
its original position to complete
the re-installation.
V1