Specifications - XYZ Printing da Vinci 1.1 Plus Quick Manual

5.Clean the detecting pin
Select "Clean Nozzle" function, and brush the molten filament and dust from the detecting pin while the
extruder is heated up.
Activate " Setting" > "Printer Settings">
"Maintenance">"Clean Nozzle".
6.Level the print bed
1.The value indicates the height of point
2. Turn the 3 turning screws at location "a", "b", "c" under the print bed to level the platform.
P3
How to adjust :
• Turn clockwise to raise, turn counterclockwise to lower.
• Adjust screw a and b may offset the diagonal. (e.g. Left turn screw b will lead to the descendant of point 2.)
• Tuning the screw for a full circle will change the value by 0.5. A single push to the screw will change the
value by 0.2 to 0.25.
Thumb of rules:
• Adjust the values to the 2.3-2.6 range.
• 3 values should be no more than ±0.2 from each other.
When fi nishing the adjustment, repeat the calibration from step 2 until it shows "Calibration Completed".
Specifi cations
Model Name
Print Technology
Print Head
Build Volume
(W x D x H)
Layer
Resolution
Setting
Filament Diameter
P 11
P1
da Vinci 1.1 Plus 3D Printer
Fused Filament Fabrication(FFF)
Single Head
20 x 20 x 20 cm
Standard 200 microns
Speed 300 microns
Ultra fast 400 microns
Custom 100-400 microns
1.75mm
Clean the detecting pin with the copper brush
Clean the 3 measurement points
P2 P3
; greater value indicates the higher the detected point is.
P1
P2
Nozzle Diameter
AC Input
Connectivity
Display
Control Method
Indicator
Weight
0.4mm
100 - 127V~4.0A 50/60Hz
200 - 240V~2.0A 50/60Hz
USB 2.0 / WiFi
LAN / USB Flash Drive
5" TFT LCD
Touch Panel
Speaker
27 Kg
V1