Installation - Zanussi ZOG15311 User Manual

Problem
Steam and condensation settle
on the food and in the cavity of
the oven.
The display shows "12.00".
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

WARNING!
Refer to Safety chapters.
Gas connection
WARNING!
Before the gas connection,
disconnect the mains plug from the
mains socket or deactivate the fuse
in the fuse box. Close the primary
valve of the gas supply.
The gas supply ramp is on the rear side of the
appliance.
WARNING!
Do not use rubber flexible pipes!
Do not fully put the oven into the built-in cabinet
(approximately 30 cm).
Connection with a flexible metallic pipe or
a rigid metallic pipe:
16
Possible cause
You left the dish in the oven for
too long.
There was a power cut.
We recommend that you write the data here:
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
Reset the clock.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
.........................................
.........................................
.........................................
A
A) Gas supply ramp, end of shaft with ramp
B) Washer
C) Elbow
Put the supplied gasket between the pipe and
the gas supply ramp. Turn the pipe to the 1/2"
gas supply ramp.
1. Use a 22 mm spanner to tighten the nuts.
Keep the gas supply ramp in the correct
position. Do not apply force to the gas
supply circuit.
WARNING!
Do not use a flame to check for
leaks!
2. Fully move the oven into the built-in cabinet.
Remedy
B C
www.zanussi.com