Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZOG15311
Summary of Contents for Zanussi ZOG15311
- Page 1 User Manual Oven ZOG15311...
-
Page 2: Table Of Contents
Cleaning and user maintenance shall not be made by children • without supervision. Children of less than 3 years should be kept away unless • continuously supervised. General Safety Only a qualified person must install this appliance and replace • the cable. www.zanussi.com... -
Page 3: Safety Instructions
Service Centre. same height. • Do not let mains cables touch or come near • Do not operate the appliance without the the appliance door, especially when the door cavity bottom cover. It is a functional safety is hot. component. www.zanussi.com... - Page 4 • Make sure that the ventilation openings are not blocked. • Do not let the appliance stay unattended during operation. • Deactivate the appliance after each use. www.zanussi.com...
- Page 5 • Do not clean the catalytic enamel (if applicable) with any kind of detergent. Internal light • The type of light bulb or halogen lamp used for this appliance is only for household appliances. Do not use it for house lighting. www.zanussi.com...
-
Page 6: Product Description
Remove all accessories and removable shelf or when the timer is not set. supports from the appliance. Press the button to set the correct time. www.zanussi.com... -
Page 7: Changing The Time
It then cycles on and off to the temperature to the Off position "0", wait for show that the temperature adjusts. one minute and then repeat the lighting operation. www.zanussi.com... - Page 8 Off position, wait for one minute then repeat turn the knob for the oven functions to the operations described above. and set the maximum temperature. 3. Adjust the grill and the deep pan runner position to allow for different thickness of food. www.zanussi.com...
-
Page 9: Clock Functions
2. Press and hold The clock function goes out after some 2. Press to set the time for the seconds. necessary clock function. The clock function operates. The display shows the indicator for the clock function you set. www.zanussi.com... -
Page 10: Using The Accessories
3. Put the spit frame on the third shelf position If a clock function (Duration or End) from the bottom. ends and you do not deactivate the appliance, the turnspit continues to operate for the next 10 minutes. www.zanussi.com... -
Page 11: Additional Functions
Cooking tables change the baking results and cause damage to the enamel. Preheat the empty oven for 10 minutes before cooking. Baking cakes • Do not open the oven door before 3/4 of the set cooking time is up. www.zanussi.com... - Page 12 Shelf position Tempera- Time (min) ture (°C) Flat cake 0.6 - 1.0 170 - 180 20 - 30 Sponge cake 1.0 - 1.5 170 - 180 40 - 50 Feter Mshaltet 1.2 - 1.5 3 or 4 40 - 45 www.zanussi.com...
- Page 13 Fish fillet max. 12 - 14 10 - 12 Toasted 4 - 6 max. 5 - 7 sandwiches Toast 4 - 6 max. 2 - 4 2 - 3 Turnspit Preheat the empty oven for 3 minutes before cooking. www.zanussi.com...
-
Page 14: Care And Cleaning
• To clean the door gasket, refer to the 3. Close the oven door to the first opening general information about cleaning. position (halfway). Then pull forward and remove the door from its seat. Removing the shelf supports To clean the oven, remove the shelf supports. www.zanussi.com... -
Page 15: Replacing The Lamp
The oven does not operate. The home gas safety valve, if in- Make sure that the home gas stalled in the home circuit, is safety valve is open. If the prob- closed. lem continues, please contact a qualified person. www.zanussi.com... -
Page 16: Installation
Do not apply force to the gas (approximately 30 cm). supply circuit. Connection with a flexible metallic pipe or WARNING! a rigid metallic pipe: Do not use a flame to check for leaks! 2. Fully move the oven into the built-in cabinet. www.zanussi.com... - Page 17 1. Disconnect the appliance from the electricity. 2. Release the screw (C), which keeps the 2. Turn the knob for the gas control to the burner in position. minimum position and remove it. 3. Adjust the adjustment screw (A) with a thin- bladed screwdriver. www.zanussi.com...
- Page 18 130 cm² in the cabinet must agree with the related front or on the sides (a minimum of 65 cm² illustrations. for each side). The manufacturer recommends a 130 cm² opening in the front www.zanussi.com...
-
Page 19: Electrical Installation
Gas original: G20 (2H) 20 mbar = 2.7 kW Gas replacement: G30 (3+) 28-30 mbar = 2.7 kW G31 (3+) 37 mbar = 2.7 kW Electric supply: 220 - 240 V ~ 50 / 60 Hz Appliance category: II2H3+ www.zanussi.com... -
Page 20: Environment Concerns
Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com... - Page 21 www.zanussi.com...
- Page 22 www.zanussi.com...
- Page 23 www.zanussi.com...
- Page 24 www.zanussi.com/shop...