Suzuki RGV250 1989 Manual page 33

REPLACING FRONT FORK PARTS
• Fit the O-ring © , ball and spring © t o the com­
pression damping adjuster ® .
NOTE:
Locate the spring so
opposite to the bail.
that its end gap comes
• install the compression damping adjuster® sub-
assembly.
Tightening torque:
Compression damping: 150 - 200 N*m
adjuster (15.0 - 20,0 kg-m)
• Install the oil lock piece ® t o the outer t u b e ® .
• Insert the inner tube © with the piston ©
fitted, into the outer t u b e ® .
® Fit the slide metal © , washer © and oil seal ©
over the inner tube and the into the outer tube
bore. Use the special tool to fit them together
into the outer tube.
Specie! tool:
09940-50112: Oil sea! installer
NOTE:
The pjirten © , slide metal © and oil seal ©
myst be replaced with new ones.
© F i t the stopper ring (JJ) and dust seal ®.
MOTE
Make
fitted
sure that the stopper ring
into the graowe.
is correctly
• Install the inner rod assembly ® .
• Fit and tighten the inner tube cylinder b o l t ® .
This time, use the special tool to hold the inner
rod,
Special tool:
09940-31710: Front fork assembling tool
Tightening torque:
Inner tube cylinder bolt: 300 — 40 N*m
( 3 0 . 0 - 4 0 . 0 kg^m)