3. Confirm the password.
4. Click the OK button to activate the device.
When the device is not activated, the basic operation and remote operation of device
cannot be performed.
5.2 Editing Network Parameters
Purpose:
You can edit the network parameters of online devices.
Steps:
1. Select an online device in the online devices list in the lower part of the batch
configuration software interface.
2. Click the Edit NET Parameters button.
3. Enter a new IP address, subnet mask, gateway address, port No. and the password.
4. Click the OK button to accomplish the editing.
The default port No. is 8000.
After editing the network parameters of device, you should add the devices to the
device list again.
Video Intercom Indoor Station·Quick Start Guide
23
Figure 5-2 Edit NET
Parameters
Figure 5-3 Edit Network
Parameters