Assembly - Efco SA 9500 Operator's Instruction Manual

WARNING: Beware of carbon monoxide
poisoning.
en
• Do not operate blower from a ladder, in a tree
or on a root top. Always work from a firm-
footed and safe position.
GB
• Do not work near electric cables.
• Keep the handle dry, clean, and free of oil or
F
fuel mixture.
• Stand with your weight evenly balanced on
both feet.
D
• Do not overreach. You could be drawn or
thrown off balance and lose control of the
E
blower.
Precautions to Reduce Vibration Risk
NL
· The blower is provided with anti-vibration (AV)
system; never alter or modify it.
P
· Wear gloves and keep your hands warm.
· Maintain a firm grip at all times, but do not
squeeze the handles with constant, excessive
GR
pressures, take frequent breaks. All the above
mentioned precautions do not guarantee that
TR you will not sustain whitefinger disease or
carpal tunnel syndrome. Therefore, continual
and regular users should monitor closely the
CZ
condition of their hands and fingers. If any of
the above symptoms appear, seek medical
advice immediately.
SK
Maintenance Precaution
RUS
WARNING: Never operate a blower that is
damaged, improperly adjusted, or is not
UK
completely and securely assembled.
WARNING: All blower service, other
PL
than items in the Operator's Manual
maintenance instructions, have to be
H
performed by competent blower service
personnel. (If improper tools are used to
remove the flywheel or clutch, or if an
LV
improper tool is used to hold the flywheel in
order to remove the clutch, structural damage
EST to the flywheel could occur which could
subsequently cause the flywheel to burst and
serious injury could result.)
LT
WARNING:
RO
Never modify your blower in any way.
Keep the handles dry, clean, and free of oil or
fuel mixture.
8
WARNING: Use only accessories and
replacement parts recommended.
• Never attempt to service the blower while
the engine is running.
• Never use fuel for cleaning operations.
• Keep the blower in a dry place, off the ground
and the tanks empty.
• If your blower is no longer usable, dispose of
it properly without
environment by handing it in to your local
Dealer who will arrange for its correct
disposal.
• Replace immediately any safety device when
damaged or broken.
WARNING: The muffler and other parts
of the engine (e.g. fins of the cylinder,
spark plug) become hot during operation
and remain hot for a while after stopping the
engine.
To reduce risk of burns do not touch the
muffler and other parts while they are hot.

4. ASSEMBLY

Assembling the tubes/handgrip
WARNING – When fitting the tube and
nozzle, the engine must be off and the switch
in the STOP position.
To assemble the blower read the following
instructions.
Machine components
Refer to Fig.3:
1. Insert the elbow tube into the fan casing.
2. Secure the elbow with the two screws and
two nuts supplied using the hex wrench
incorporated in the spark plug wrench
(supplied).
Refer to Fig.2:
1. Fit the hose clamps on the two ends of the
flexible tube (10, Fig.1), without tightening
them.
2. Fit the flexible tube onto the elbow tube (9,
Fig.1) and onto the blower tube (12, Fig.1)
taking care to ensure that the cone (A, Fig.2)
is positioned towards the blower tube; now
tighten the two hose clamps using the
damaging the