Cleaning The Water Intake Fi Lter; Cleaning The Spray Arms - AEG F45078I-M General Manual

EN
5.2

Cleaning the water intake fi lter

Clean the water inlet fi lter at regular intervals. After closing the delivery tap, un-
screw the ring nut (ref. A fi g. 5-01) on the water inlet pipe (using a pair of pliers,
if necessary) and delicately clean the fi lter, removing deposits or impurities. Then
fi rmly fi x the pipe by tightening the ring nut (ref. A fi g. 5-01) (use a pair of pliers,
if necessary).
5.3

Cleaning the spray arms

The spray arms can be easily removed for periodic cleaning of the nozzles, to pre-
vent possible clogging. Wash them under running water (at room temperature)
and carefully replace them in their seats, checking that their rotary movement
is in no way impeded; if this is not the case, make sure they have been mounted
properly.
Removing the spray arms
• To remove the upper spray arm (ref. A fi g. 5-02), unscrew the locking ring (ref.
B fi g. 5-02) by turning it clockwise. After cleaning, remount the spray arm in its
seat and tighten the locking ring by turning it anti-clockwise.
• To remove the lower spray arm (ref. A fi g. 5-03), simply lift it up, pulling by the
central part (see fi g. 5-03). Then remount the lower spray arm into its seat and
push it down slightly until it click into place (see fi g. 5-03).
36
USER INSTRUCTIONS
A
Fig. 5-01
Rev 0.0