Crankcase and crankshaft on
350/345/340 – reassembly
1
Lubricate the bearings with grease and press them
onto the crankshaft. Use sleeve 502 54 20-01 to fit
the bearing on the clutch side.
2
Press the crankshaft into the bearing housing.
3
Apply silicone rubber 503 26 70-01 to the surfaces
of the crankcase that mate with the bearing hous-
ing (350), lower cylinder face (340/345).
4
Fit the bearing housing and tighten the four bolts to
a torque of 14–16 Nm.
NOTE!
If a new crankshaft has been fitted the
saw must be run in for 3-4 hours with the
carburettor adjusted to the factory set-
tings.
5
Refit the following parts:
fuel tank
piston and cylinder
silencer
carburettor
oil pump
centrifugal clutch
ignition system
cable guide and starter assembly page 25
cylinder cover
clutch cover
guide bar and chain
Repair instructions
page 39
page 42
page 14
page 35
page 30
page 30
page 25
45
English –