3
Fit the carburettor. Screw in the carburettor bolts
directly from behind, without lifting the carburettor
assembly. Tighten to a torque of 1–1.5 Nm. It is
important to hold the carburettor flange while
tightening the bolts to prevent the inlet manifold
from moving.
4
Push the rear carburettor mounting into its rubber
bushing using a small screwdriver. Remove stop
plate 502 54 17-01.
5
Connect the fuel hose to the carburettor. Connect
the throttle pushrod at the same time as the rubber
inlet manifold, press in the throttle pushrod so that
it engages in the carburettor and fit the spring.
6
Fit the throttle lock by pressing the spring back and
pressing the throttle lock forwards into position.
Then press the throttle lock to the left and down-
wards at the same time. Repeat this procedure,
this time pressing the throttle lock to the right.
When you have heard two clicks the throttle lock is
correctly positioned.
7
Connect the leads to the stop switch.
8
Fit the silencer with the cooling plate and gasket
(plus silencer support), tightening the bolts to a
torque of 8–10 Nm.
9
Connect the HT lead.
Fit the air filter.
Fit the cylinder cover, tightening the bolts to 2–3
Nm where applicable.
10
After pressure testing, re-tighten the silencer bolts
to a torque of 8–10 Nm.
Repair instructions
35
English –