Roland R-09 Service Notes page 13

Apr. 2006
7.
Connect the PC to the R-09 with the USB cable.
8.
Display the SD card for the R-09 on the PC's screen, then copy the system-
update file to the root directory of the SD card.
Four types of system-update files are available.
DMZ15.UPD: Update for all blocks
DMZ15_BOT.UPD: Update for the Boot block
DMZ15_UPD.UPD: Update for the Updater block
Update for the Main Program block
DMZ15_PRG.UPD:
9.
When copying is finished, refer to the R-09 Owner's Manual and follow
the instructions in "Disconnecting the PC" (p. 59) to disconnect the R-09
from the PC.
10. Turn off the power to the R-09.
System Update Procedure
When performing a system update, be sure to use the AC adaptor. If this is
attempted using battery power, a low battery during the procedure may cause
the update to fail and cause the unit not to operate correctly.
Never disconnect the AC adaptor while the update is in progress. Doing so
may corrupt the system and cause the unit to fail to operate correctly.
1.
Turn off the power to the R-09.
2.
Using the update-use SD card created according to the procedure
described in the section of "Creating an update SD card," insert the
update-use SD card into the card slot in the R-09.
3.
While holding down the [REC] button, turn on the power.
When a valid update-use file is found on the SD card, the Program
Update screen like the one shown below appears.
* The screen that is displayed differs according to the type of update-use file.
DMZ15.UPD (update for all blocks)
fig.upd-all_90
DMZ15_BOT.UPD (update for the Boot block only)
fig.upd-boot_90
DMZ15_UPD.UPD (update for the Updater block only)
fig.upd-updr_90
DMZ15_PRG.UPD (update for the Main Program block only)
fig.upd-prg_90
If no SD card is inserted, a screen like the one below appears.
fig.nocard_90
If no valid update-use file exists on the SD card, a screen like the one below
appears.
fig.nofile_90
R-09
13