Call Screening Functions - Pace 56 Solo Manual

To delete all messages
(cannot be done while playing messages):
Press the ERASE and
ANSWER PHONE buttons
simultaneously.
• The ANSWER PHONE button
will darken.
Note: The ANS button will flash when the message memory
is 90% full. Use the delete function to free memory.
To listen to the outgoing message:
Press the ANN button.
• You will hear the current
message that is played to
callers as their calls are
answered.
To re-record the outgoing message:
Press the ANN and ERASE
buttons simultaneously.
• The ANSWER PHONE button
will glow to indicate that
recording is in progress.
• Speak your new message
clearly, approximately 20cm from your Solo. Your
outgoing message can be up to 50 seconds long.
To finish recording:
Press the ANSWER PHONE button.

Call Screening Functions

As part of the digital answer phone, your Solo allows you to
screen incoming calls in two ways:
• by monitoring the caller's message before deciding to
pick up, and
• by using the Caller ID feature to identify the caller's
phone number*.
To switch Call Monitoring ON:
Press the FAX and
SPEAKER PHONE
buttons.
• The SPEAKER
PHONE button will
flash continuously.
• You will now be able to hear each caller as they leave
their message and decide whether or not speak to
them.
Note: If your phone line has a caller identification service,
then your Solo will announce the caller's phone number
prior to answering - whenever Call Monitoring is switched
on.
*
You must subscribe to the caller identification service operated
by your telephone company (such as Caller Display from BT) to
fully use the Caller ID feature.
Using Solo in Stand-alone Mode 9