If the garage door or other device does not operate, proceed to "Pro-
●
gramming a rolling code system".
Repeat the steps above to program another device for any of the remaining
5
HomeLink
Programming a rolling code system
■
Locate the "Learn" or "Smart"
1
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by man-
ufacturer. Refer to the owner's man-
ual supplied with the garage door
opener motor for details.
Press and release the "Learn" or
2
"Smart" button.
Perform
after performing
Press and hold the desired
3
HomeLink
vehicle) for 2 seconds and
release it. Repeat this sequence
(press/hold/release) up to 3
times to complete programming.
If the garage door opener motor
operates when the HomeLink
ton is pressed, the garage door
opener motor recognizes the Home-
®
Link
signal.
ES300h_OM_OM33C75U_(U)
6-4. Using the other interior features
®
buttons.
within 30 seconds
3
.
2
®
button (inside the
®
but-
417
6