Setting The Program Mode - FPI FireGenie Operating Instructions Manual

It is recommended to unplug the unit while setting the programs.
In this mode, the user can program two On-Times and two Off-Times as well as the
Temperature settings for each day of the week. The AUTO/MAN/PROG button is used to
initiate the programming mode. The "+" and "-" buttons are used to adjust the time and
temperature settings.
Note: The remote needs to be ON in order to set the Programs.
Follow the steps below to set the programs:
1) Programming the On-Time of Time Zone 1
Press and hold the AUTO/MAN/PROG button for 2 seconds or more to initiate
the Programming mode.
The symbol "PROG 1" will flash to indicate the Remote is in Programming mode.
The On-Time for Time Zone 1 will also flash. The "+" and "-" buttons can be
used to adjust this time setting.
The LCD will show the current setting in Time Zone 1 for Monday:
Page 12

SETTING THE PROGRAM MODE

Programming of Time Zone 1
Time Zone 1 On-Time
FPI FireGenie TM Remote Control Manual