Table of Contents
Advertisement
Maintenance
CLEANING
First of all disconnect the machine from power source.
•
Remove the upper door by unscrewing the screws of the hinges.
•
Remove the lower door doing as above.
•
Remove the blade by turning blade calibrator knob counter-clockwise, then loosen the blade and pull it out.
•
Take out upper and lower wheels by pulling staples out, which are located in front of the wheels.
•
Never use hard tools such as: knives, forks, hooks, or others to remove stuck pieces of cut meat from the
upper and lower doors. To do that use a plastic brush.
•
Assemble the components following the inverse steps.
NOTE: The sharp edge of the blade must be facing the front of the machine.
All removable components must be washed with warm water and neutral soap. Be careful when washing the
blade. It has a sharp edge that could cause serious irreparable injuries to the hands.
CAUTION: The machine is not protected against water jets. Do not clean it with steam jets, or high
pressure blasts or similar methods. Under no circumstances should the bandsaw be hose rinsed as
this may result in short circuit or serious damage to the machine.
Clean the body of the machine with a damp clean cloth and wipe dry.
REFERENCE
Item Number Model Number
10272
BS-VE-3200-S
18943
BS-VE-3200-T
Description
Band Saw 126" / 3200mm Blade
3 HP / 2237W 220V/60/1 ETL
Band Saw 126" / 3200mm Blade
3 HP / 2237W 220V/60/3 ETL
8
Manufacturer Model Number
B40
B40-3PH
Advertisement
Table of Contents
