Table of Contents
Advertisement
OPERATION
Switch on the machine pressing the on/off switch.
Put the product to be processed onto the table, pushing it to the direction of the blade lined up by the cutting
regulator (optional), maintaining the thickness of the slice desired.
When pulling back the product do not touch the blade avoiding disconnecting it from the wheels.
Drop a little bit of water onto the fixed table to facilitate the slipping of the product.
COMPONENTS ADJUSTMENT
PULLEY BELT
•
The belt must be firmly fixed to prevent it from skidding. Do not tighten it too much because it can wear out
quickly.
•
To have access to the belt remove the screws with a screwdriver from the inferior back lid and take it out.
•
With a screw-wrench loosen the screws turning it counter-clockwise. To stretch out the belt you have to
push the motor with the wood lever tightening the screws.
IMPORTANT: The pulleys must be lined up.
UPPER BEARING ADJUSTMENTS
•
The purpose of this adjustment is to centralize the blade on the gear and avoid it falling down.
•
First of all disconnect the machine from the electricity supply. Then loosen blade turning handle counter-
clockwise.
•
Take out upper back lid by removing screws using the screwdriver. Loosen the three screw-nuts using a
10mm screw-wrench.
•
Using the screwdriver turn the screw-nut ¼ counter-clockwise if the wheel is inclined towards the front or
turn it ¼ clockwise if it is inclined backwards. Tighten the three screw-nut previously loosen. Calibrate the
blade according to pre-operation.
•
Turn the wheels manually to check if the blade is centralized, if it is not keep turning the wheels until the
blade is centralized.
CUTTING REGULATOR
•
The cutting regulator (optional) was designed to provide cuts with the same thickness and also to protect
the operator from getting injured.
•
To adjust the cutting regulator proceed as follows:
Turn locking knob counter-clockwise to be able to move the cutting regulator to the left and right according
to the distance you want to leave from it to the blade.
•
Then turn the locking knob clockwise to fix the cutting regulator in the desired position.
Maintenance
7
Operation
Advertisement
Table of Contents
