MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the like.
•
Discoloration, deformation or cracks may result.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when
they wear down to the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both carbon brushes should
be replaced at the same time. Use only identical carbon brushes.
1
2
011473
Insert the top end of slotted bit screwdriver into the notch in
the tool and remove the holder cap cover by lifting it up.
1
2
011474
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Reinstall the holder cap cover on the tool.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
1. Limit mark
1
1. Holder cap
cover
2. Screwdriver
1. Brush holder
cap
2. Screwdriver
OPTIONAL ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Side handle (accessory)
011467
011470
011479
011480
9
or
attachments
Only use
accessory or
are