Makita DGD800 Instruction Manual page 10

When using the side handle, remove the rubber
protector, insert the side handle on the tool barrel as far
as it will go and rotate it to the desired angle. Then
tighten the handle firmly by turning clockwise.
CAUTION:
When using the tool without handle, always install
•
the rubber protector on the tool.
When installing the rubber protector, always push
•
it onto the tool so that the top round recessed
shape of the rubber is positioned near the switch
position.
Wheel points
•
Collet cone (3 mm, 6 mm, 8 mm, 1/4", 1/8")
•
Collet nut
•
Wrench 13
•
Side handle set
•
Makita genuine battery and charger
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
10