Status Lights - Pace 5111NV Installation Manual

Status lights

Use the status lights on the front of the gateway to determine the current state of the
gateway.
Status light
Power
Ethernet
Wireless
Phone 1 and 2
USB
Broadband
Service
Chapter 3 Troubleshooting
Description
• Solid green. Power is on.
• Red. The gateway is faulty.
• Solid green. A computer or other device is
connected to an ETHERNET port.
• Flickering green. There is activity from devices
connected to an Ethernet port. The flickering of the
light is synchronized to actual data traffic.
• Solid green. A wireless computer or other device is
connected.
• Flickering green. There is inbound or outbound
activity. The flickering of the light is synchronized to
actual data traffic.
• Solid green. A phone is connected.
• Flashing green. The associated phone is active.
• Solid green. A device is connected to the USB port.
• Flashing green. The USB device is active.
• Solid green. The gateway is connected to the
service provider network.
• Flashing green. The gateway is attempting to
establish a connection to the service provider
network.
• Red. There is no DSL signal.
• Solid green. The gateway has obtained a WAN IP
address from the service provider through the
DHCP or PPP connection and the broadband
connection is up.
• Fast flashing green. The gateway is attempting to
obtain an IP address.
• Slow flashing green. The service provider network
is not responding, the gateway has been configured
incorrectly, or there was an authentication failure.
15